Since many of you like to tinker and create their own housings for their allsky setups, we've been asked to share STEP files of our products. These STEP files can be imported into most 3D design programs. You will be able to design your enclosure around the SkyCamOne HATs, dew...
New dew heaters in stock
We thought we'd post just a short update to notify you that we have our new dew heaters back in stock. Those of you that had outstanding orders with dew heaters included should receive shipping updates these days. The new dew heaters are perfectly rated at 3.5 Watts and as...
New products available
We are delighted to be able to tell you that we are adding two new products to our store. Two products that are indispensible for nearly every allsky camera. 1/2" 1.55mm F2.0 5MP CS mount fisheye lens IP68 RJ45 CAT6 Waterproof Panel Ethernet Connector This is the perfect allsky lens for most...
SkyCamOne HAT for RPi 4B – Revision C
So, last week we discovered a design flaw in our SkyCamOne HATs for Raspberry Pi 4B. The flaw is in the buck converter circuit where we convert the incoming power from PoE or 12 volts in into 5 volts. These 5 volts are used to power your Raspberry and the...
TJ Allsky configuration
Today, we've added a guide describing how to configure TJ Allsky to work with your SkyCamOne HAT. We tell you how to set up the different features of your SkyCamOne HAT; Stepper motor for remote focus SHT31-D Temperature and Humidity sensor connected with a QWIIC cable Dew heater We hope...
Easy software installation
In order for your experience with your Titan Astro SkyCamOne HAT to be as good as it can be, we've tried to simplify the installation and configuration. Your SkyCamOne HAT comes with a Quick Start Guide. How to mount the HAT on top of your Raspberry Pi is described in...
We’re almost done!
So, finally in week 6 of the year we will finish shipping out the remaining SkyCamOne HATs for Raspberry Pi 5. All the SkyCamOne HATs for Raspberry Pi 4B went out last week, except those orders in which both HATs were included. This gives us space and time to start...
First SkyCamOne HATs shipped
We've come a long way since we started all this in the beginning of last year. We had to navigate through some tough situations but we're finally enjoying the uptimes. All thanks to you, our customers! Our team here at Titan Astro is delighted to see how we have managed...
Presenting our new environmental sensor
This Titan Astro sensor board is based on the famous Sensirion SHT31-D sensor, providing humidity, temperature and pressure readings via I2C (QWIIC) to the SkyCamOne HAT. We've designed this extra small breakout board so it can be easily fixed with a screw or clip. We've placed the sensor in a thin section of the board on purpose, so...